How to Install Ubiquiti UniFi Controller 4 on the Raspberry Pi
Please share with your friends...
  • 13
  • 1
  •  
  • 19
  • 11
  • 1
  •  
  •  
  •  
  •  
    45
    Shares

The Ubiquiti Networks UniFi Controller enables administrators to instantly provision and configure thousands of UniFi APs, allowing for quick, simple management of system traffic. A single UniFi Controller can manage multiple sites: multiple, distributed deployments and multi-tenancy for managed service providers.

This post describes how to install the UniFi Controller software Version 4 on Raspberry Pi.

This post has been superseded by our newer How to Install Ubiquiti UniFi Controller 5 on the Raspberry Pi guide.
For specific instructions on how to upgrade your UniFi Controller software from Version 4 to Version 5, please refer here.
The UniFi Controller and mFi Controller software can co-exist on the same Raspberry Pi
The instructions in this article have been tested with Raspbian Stretch Lite (November 2017) and UniFi 4.8.20.

Contents


The Shortlink to this post is http://www.technologist.site/?p=2547.

If you found this post helpful or useful in some way, please help us by doing the following:

  • Like or link to this post from your favourite social media platforms;
  • Click our advertisers banners;
  • Make a Purchase through our associates links;
  • Make a Paypal Donation;
  • Leave a Reply below.
Thank you!

Chris

⇓ LastPageNext ⇒

Raspberry Pi is a trademark of the Raspberry Pi Foundation. UBNT, mFi® and UniFi® are trademarks of Ubiquiti Networks, Inc.
How to Install Ubiquiti UniFi Controller 4 on the Raspberry Pi

Please share with your friends...
  • 13
  • 1
  •  
  • 19
  • 11
  • 1
  •  
  •  
  •  
  •  
    45
    Shares
Tagged on:                                             

Leave a Reply

Your email address will not be published. Required fields are marked *